Collimatore Laser 31,8mm TS Teleskop Service

LA2

Nuovo

Collimatore Laser TS da 31,8mm

49,00 € -

Aggiungi alla lista dei desideri

Segui il prezzo

Segui il prezzo di questo articolo, non perdere alcuna promozione! Inserisci la tua email e conferma, se ci saranno sconti sarai avvisato!

Email non valida

Conferma

Collimatore Laser TS da 31,8mm

Short manual - how to use the LA2 laser collimator:



1. Preparation: Turn the tube into a horizontal position and rotate it so that the focuser points upwards. Then you insert the laser into the 1.25" receptacle. The collimator should not be clamped in order to prevent tilting. A tilted laser would degrade the collimation result.

2. Collimation of secondary mirror: Switch on the laser diode, look into the tube to the primary mirror and use the collimation screws of the secondary mirror until the laser dot is centered on the primary mirror. A center marking (hole reinforcement ring) is recommended for this.

3. Primary Mirror Collimation: Turn the laser collimator so that you can see inside the 45° angled view port from the rear end of the telescope. If the optics is coarsely pre-adjusted, you can already see the reflected spot on the plate. Then use the primary mirror collimation screws until the returning laser dot hits the center bore of the laser. (Image at left - here, the primary mirror has the be adjusted a bit more.)

Voto 
21/01/2017

ottimo per il mio 200 skywatcher

ottimo per il mio 200 skywatcher

    Voto 
    11/01/2017

    Collimatore semplice e utile

    Collimatore semplice e utile da utilizzare sul newton o dobson con una piccola spesa

      Scrivi una recensione!

      Scrivi una recensione

      Collimatore Laser 31,8mm TS Teleskop Service

      Collimatore Laser 31,8mm TS Teleskop Service

      Collimatore Laser TS da 31,8mm

      Prodotti Correlati